Sunday, August 12, 2012


Sorry it has been awhile for a post.  Between the heat (110 yesterday) and my “daytime job” I have not had a lot of shop time.

Steve Good had created a pattern for a vase.  This was something I did not think I could pull off because of the angled cuts.  Each piece is cut at a 15 degree angle.  I ended up deciding to give it a shot.  After lots of sanding and several coats of polyurethane here is the final product.


Below is a picture of an upcoming project.

1 comment:

Tami said...

Tim, that is beautiful!!! You did a wonderful job!!!

Site Meter